Electro-mechanical Assembler

Electro-mechanical Assembler

Work Location: California

Job type: Full-Time

Posted: 10-15-2018

Salary: 11 - 14 USD / Hourly

Email: Marita@ajobstaff.com

Job Description

A privately-owned company located in the City of Orange is looking for qualified electronic and mechanical assemblers to assist on the manufacturing of their in-house designed cost effective uninterruptible power systems (UPS) and power conversion products for rugged and harsh indoor and outdoor environments. 

·         Position: Electro-mechanical Assembler

·         Pay rate: $11-$14 DOE

·         Schedule: Mon-Fri 7am – 3pm, plus OT

Send us your resume via email for immediate consideration, or apply in person at our Santa Ana Office. You can also send us call us for more info

·         Address:              2708 Westminster Ave, Ste 210, Santa Ana, CA 92701

·         Email:                    job@ajobstaff.com

·         FB:                          www.facebook.com/ajobstaffing

        Phone:                   562.691.4266

Job Responsibilities

  • ·         Prepares work to be accomplished by studying assembly instructions, blueprint specifications, and parts lists; gathering parts, subassemblies, tools, and materials.
  • ·         Positions parts and subassemblies by using templates or reading measurements.
  • ·         Perform a wide variety of electronic and electro-mechanical assembly operations on assemblies and sub-assemblies.
  • ·         Follows methods and sequence of operations in performing wiring, component installation, hand soldering, and cable harnessing on assembly units.
  • ·         Makes setups and adjustments holding tolerances to blueprints specifications.
  • ·         Has substantial understanding of the job and requires considerable judgment and initiative.
  • ·         Understands implications of work and make recommendations for solutions
  • ·         Determines methods and procedures on new assignments
  • ·         Normally receives little instruction on daily work, general instructions on newly introduced assignments.

Job Requirements

  • ·         Requires at least 3 years experience of electro-mechanical assembly
  • ·         Must know how to Solder and de-solder
  • ·         Must be able to read blueprints
  • ·         Experienced on the use of wire cutters, wire stripper, crimping tools,
  • ·         Experienced with wires, wiring and harnessing assembly
  • ·         Knowledge in IPC610 and clean manufacturing a Plus.

SUBMIT RESUME

Just fill out the short form below. Thank you!

(3MB upload size limit)