Electro-Mechanical Assembler

Electro-Mechanical Assembler

Work Location: California

Job type: Full-Time

Posted: 02-05-2019

Salary: 12 - 14 USD / Hourly

Email: Victoria@ajobstaff.com

Job Description

 

A privately-owned company located in the City of Orange is looking for qualified electronic and mechanical assemblers to assist on the manufacturing of their in-house designed cost effective uninterruptible power systems (UPS) and power conversion products for rugged and harsh indoor and outdoor environments. 

 

Position: Electro-mechanical Assembler

 

Pay rate: $12-$14 DOE

 

Schedule: Mon-Fri 7am – 3pm, plus OT

 

Send us your resume via email for immediate consideration, or apply in person at our Santa Ana Office. You can also call us for more info

 

 Address:              2708 Westminster Ave, Ste 210, Santa Ana, CA 92701

 

Email:                    job@ajobstaff.com

 

FB:                        https://www.facebook.com/ajobstaffSA

 

Phone:                   562.691.4266

 

Job Responsibilities

 

  • Prepares work to be accomplished by studying assembly instructions, blueprint specifications, and parts lists; gathering parts, subassemblies, tools, and materials.
  • Positions parts and subassemblies by using templates or reading measurements.
  • Perform a wide variety of electronic and electro-mechanical assembly operations on assemblies and sub-assemblies.
  • Follows methods and sequence of operations in performing wiring, component installation, hand soldering, and cable harnessing on assembly units.
  • Makes setups and adjustments holding tolerances to blueprints specifications.
  • Has substantial understanding of the job and requires considerable judgment and initiative.
  • Understands implications of work and make recommendations for solutions
  • Determines methods and procedures on new assignments
  • Normally receives little instruction on daily work, general instructions on newly introduced assignments.

 

Job Requirements

  •  
  • Requires at least 3 years experience of electro-mechanical assembly
  • Must know how to Solder and de-solder
  • Must be able to read blueprints
  • Experienced on the use of wire cutters, wire stripper, crimping tools,
  • Experienced with wires, wiring and harnessing assembly
  • Knowledge in IPC610 and clean manufacturing a Plus
  •        Knowledge on Power Supplies a Plus

 

SUBMIT RESUME

Just fill out the short form below. Thank you!

(3MB upload size limit)