Electro-Mechanical Assembler

Electro-Mechanical Assembler

Work Location: California

Job type: Full-Time

Posted: 06-18-2018

Salary: 11 - 14 USD / Hourly

Email: job@ajobstaff.com

Job Description

A privately-owned company located in the City of Orange is looking for qualified electronic and mechanical assemblers to assist on the manufacturing of their in-house designed cost effective uninterruptible power systems (UPS) and power conversion products for rugged and harsh indoor and outdoor environments. 

  • Position: Electro-mechanical Assembler
  • Pay rate: $11-$14 DOE
  • Schedule: Mon-Fri 7am – 3pm, plus OT

Submit your resume through this post, or apply in person at our Santa Ana Office. You can also send us your resume via email or through our Facebook page

  • Address:              2708 Westminster Ave, Ste 210, Santa Ana, CA 92701
  • Email:                    job@ajobstaff.com
  • FB:                          www.facebook.com/ajobstaffing

Job Responsibilities

    • Prepares work to be accomplished by studying assembly instructions, blueprint specifications, and parts lists; gathering parts, subassemblies, tools, and materials.

    • Positions parts and subassemblies by using templates or reading measurements.

    • Perform a wide variety of electronic and electro-mechanical assembly operations on assemblies and sub-assemblies.
    • Follows methods and sequence of operations in performing wiring, component installation, hand soldering, and cable harnessing on assembly units.
    • Makes setups and adjustments holding tolerances to blueprints specifications.
    • Has substantial understanding of the job and requires considerable judgment and initiative.
    • Understands implications of work and make recommendations for solutions
    • Determines methods and procedures on new assignments
    • Normally receives little instruction on daily work, general instructions on newly introduced assignments.

Job Requirements

  • Requires at least 3 years experience of electro-mechanical assembly
  • Must know how to Solder and de-solder
  • Must be able to read blueprints
  • Experienced on the use of wire cutters, wire stripper, crimping tools,
  • Experienced with wires, wiring and harnessing assembly
  • Knowledge in IPC610 and clean manufacturing a Plus.

SUBMIT RESUME

Just fill out the short form below. Thank you!

(3MB upload size limit)